Intersection
Introduction

This geoprocess operates on two layers, the “input layer” and the “overlay layer”, whose geometries can be polygons, lines or points.

interseccion-en.img/interseccionAccesoNuevo_en.png

It calculates the intersection with the different geometries in the “overlay layer” for each geometry in the “input layer”, thus creating a new element for each intersection. This element will take all the alphanumerical attributes in the geometries that created it (input and overlay). This is why (it models space areas which comply with the condition of belonging to the two polygons, lines or points that created it) this geoprocess is known as “Spatial AND" operator.

An example of how this geoprocess can be applied:

Given a land use layer (e.g. Corine2000), and a national geological map layer, you can obtain a polygon layer with homogeneous information on land use and geological material.


Running the 'Intersection' geoprocess

After selecting the "Intersection" geoprocess, the following dialogue appears:

interseccion-en.img/introdcuccionDatosInterseccionNuevo_en.png

Select the input layer and the overlay layer. You must also specify a file in which to save the results. Finally, click on "Ok" and the geoprocess will be run.

interseccion.img/antesInterseccion_es.png

In this case, we will use a very simple example to better understand the function of the geoprocess. The previous figure shows two overlaying polygons. The result of launching the “Intersection” geoprocess with these layers as parameters is as follows:

interseccion.img/despuesInterseccion_es.png

Cached time 11/22/13 01:51:35 Clear cache and reload